Peugeot 308 Key Fob Replacement
Peugeot's 308 may be somewhat old-fashioned, but it is still striking. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is constant or intermittent the following tips will help.
Water Damage
If you leave your fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it's likely to sustain water damage. Keep your key fob in a dry, dry bag each time you go outside or engage in things that expose it to excessive water.
You'll also want to make sure that the fob is completely dry before opening it up and re-using it. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's submerged.
A circuit board that's wet can cause the battery to discharge its charge or even explode. If you're able to pull your key fob 308 out from the body of water it was stuck in it, flip the button side down and shake out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board down using a cotton swab that has been dipped into 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system may not function include a dead coin battery or receiver module issue, signal interference, or an electronic chip that is damaged. If none of the above are the cause you can restart the system by disconnecting the 12 volt battery from your car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to entering. This feature is extremely useful particularly during the cold winter months. Remote start systems can not function due to a variety of reasons, including the dead battery in the coin-battery.
The coin-shaped battery that is within the key fob may last between two and four years depending on how often it's utilized, the place it was purchased, and how it is used. Its use-by date is typically printed on the packaging or written in the manual.
If the key fob stops working after being exposed clean tapwater, take out the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. If peugeot 3008 key fob G28CarKeys was exposed to salty or soapy water, it could have fried the chip. It is recommended to replace it.
If you are not sure the battery is faulty You can test its voltage using a multimeter that is set to the car's voltage range, and connect it to the minus and plus terminals. The voltage should be around 12-13 volts, but if it's lower, the battery needs to be replaced. You can also try to reset your on-board computer by disconnecting the 12 volt battery for a short period of time, and reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's that part that sends an alert to the car when your key fob is activated, it also acts as an immobiliser and prevents it from starting until the correct key is used.
This could be due to a range of factors including water damage or simply ageing. If your Peugeot 308 key fob has been exposed dirty tap water, like, the electronic chip inside is damaged. In this situation, you'll need to take it out and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try again.
If the issue persists the issue persists, it's a good option to consult an area Peugeot specialist or locksmith. They can employ an instrument for diagnosing to pinpoint the problem and fix it.
It can be stressful to lose your Peugeot car key. However, a reputable auto locksmith can solve the issue in only a few minutes. They can program your car and cut a brand new, working key for you. Find the nearest locksmith.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is a very vital component of the remote control system. If it is damaged, your car might not start or you might receive a message that reads "anti-theft active". In this case, the only solution is to replace the key. Auto locksmiths with experience are able to provide the service in the shortest time.
The chip inside your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other reasons. If your Peugeot key fob has been exposed to dirty or soapy water, it must be cleaned immediately. You can wipe the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to dry completely.
Sometimes the key fob may not function due to radio interference. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects that are in the vicinity of the vehicle. If you experience this issue it is advised to visit the Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and requires special attention. It should not be dropped or throw it around. If you lose it, try to locate it as soon as you can. You can reset the onboard computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.